旋轉式傳感器通用型傳感器高轉速測試儀

Rotary sensors high precision speed universal tester

型號:G81501

Model: G81501

產品簡介：

Product synopsis:

　旋轉式傳感器：

Rotary sensors:

　本傳感器為通用型傳感器，適合于動力設備與負載之間有的距離，同時動力設備、負載是一個相對體的旋轉動力系統，需用聯軸器將傳感器安裝于動力設備與負載之間。

This sensor is a general-purpose sensor, suitable for power equipment and load, there is enough distance between power equipment at the same time, the load is a relatively independent body all the rotating power system, will need coupling sensor installed between the power equipment and the load.

轉速測量分為：

Speed measurement is divided into:

1、高轉速測量時采用光電、碼盤原理設計 。

1, high speed measurement on the principle of photoelectric and encoder design.

2、測量角度、位移及低轉速時采用增量式編碼器原理設計，測量轉速高，性能穩定，使用壽命長。

2, measuring Angle and displacement and the low speed on the principle of incremental encoder design to measure speed of high precision, stable and reliable performance, long service life.

產品特點：

Product features:

1、可測量穩態旋轉扭矩及動態過渡過程的旋轉扭矩。

1, measurable steady rotating torque and dynamic transition process of the rotary torque.

2、測量正、反向扭矩時，不需調整點。

2, measuring, positive and reverse torque does not need to adjust the zero point.

3、信號檢測采用數字化處理技術，高、穩定性好、干擾強。

3, signal detection using dial processing technology, high precision, good stability, strong anti-jamming.

4、輸入電源性、幅值保護，輸出轉矩、轉速信號保護。

4, the input power supply polarity and amplitude protection, output torque and rotational speed signal protection.

5、扭矩信號的提取方式為應變電測技術。

5, torque signal extraction method for strain electrical measuring technology.

6、扭矩測量與旋轉速度、方向無關。

6, torque measurement precision has nothing to do with the rotating speed and direction.

7、可測量正反向扭矩、轉速及功率。

7, measurable positive and negative torque, rotational speed and power.

8、輸入、輸出信號的傳輸為非接觸的耦合方式。

8, input, output signal tranission for non-contact coupling mode.

9、體積小、重量輕、安裝方便。

9, all volume, light weight, convenient installation.

10、性高、壽命長。

10, high reliability, long service life.

技術參數：

Technical parameters:

轉矩準確度：≤0.2% F·S

Torque accuracy: 0.2% or less f. S

過載能力：　150%F·S

Overload capacity: 150% f. S

緣電阻：　≥200MΩ

Insulation resistance: 200 m Ω or higher

工作溫度：　-20～60℃

Working temperature: - 20 ~ 60 ℃

重復性：　　≤0.1%F·S

Repeatability: 0.1% or less f. S

滯 后：　　 ≤0.1%F·S

After the delay: 0.1% or less f. S

線 性：　　 ≤0.1%F·S

Sex: 0.1% or less f. S

相對濕度：　≤90%RH

Relative humidity: 90% RH or less

應變計動態應變波的響應時間：3.2×10-6S

Strain gauge of dynamic strain wave response time: 3.2 x 10-6 s

轉矩頻率輸出：10KHz

Zero frequency output torque: 10 KHZ

正向轉矩滿量程頻率輸出：15KHz

Positive full range frequency output torque: 15 KHZ

反向轉矩滿量程頻率輸出：5 KHz

Reverse torque full range frequency output: 5 KHz

轉速輸出信號（光電碼盤式）：60-120個脈沖/轉 標準配置

Speed output signal (light code disc) : 60-120 pulses/standard configuration

轉速輸出信號（旋轉編碼器式）： 900-2000個脈沖/轉 選配

Speed output signal (rotary encoder) : 900-2000 pulses/roll matching

傳感器信號輸出：方波信號、幅值為5V、負載電流＜15mA

Sensor signal output: the square wave signal, amplitude of 5 v, load current < 15 ma

傳感器功耗：4W

The power consumption of the sensor: 4 w